User Tools
start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
start [2019/04/25 14:33] thierry [Troubleshooting] |
start [2019/04/25 14:38] thierry [Troubleshooting] |
||
|---|---|---|---|
| Line 46: | Line 46: | ||
| | ::: | ::: | Water inlet tubing folded or obstructed|Check that the inlet pipe is not damaged.| | | ::: | ::: | Water inlet tubing folded or obstructed|Check that the inlet pipe is not damaged.| | ||
| | ::: |- Power light ON \\ - all control light indicators OFF|Fuse in the controller box broken | Replace fuse | | | ::: |- Power light ON \\ - all control light indicators OFF|Fuse in the controller box broken | Replace fuse | | ||
| - | |Weak purified water production|- Power light ON \\ - indicator PUMP light ON \\ - Pump running continuously|Pre-treatment clogged| Replace the pre-treatment filters before the RO membrane| | + | |reduced flow of purified water|- Power light ON \\ - indicator PUMP light ON \\ - Pump running continuously|Pre-treatment clogged| Replace the pre-treatment filters before the RO membrane| |
| | ::: | ::: | Weak flow of inlet water|Increase the flow of the inlet water| | | ::: | ::: | Weak flow of inlet water|Increase the flow of the inlet water| | ||
| | ::: | ::: | Reverse osmosis membrane clogged|Change the membrane | | | ::: | ::: | Reverse osmosis membrane clogged|Change the membrane | | ||
| Line 53: | Line 53: | ||
| | ::: | - Power light ON \\ - indicator PUMP light ON \\ - Pump always OFF|Pump fuse burned |Replace the pump fuse | | | ::: | - Power light ON \\ - indicator PUMP light ON \\ - Pump always OFF|Pump fuse burned |Replace the pump fuse | | ||
| | Starts and stops continuously | Light indicators FULL and PUMP alternate| Defective high-pressure sensor or check valve|Change pressure sensor and check valve| | | Starts and stops continuously | Light indicators FULL and PUMP alternate| Defective high-pressure sensor or check valve|Change pressure sensor and check valve| | ||
| - | |Lack of pressure on water output| - Power light ON | Watertank hand valve closed|Turn ON the watertank hand valve| | + | |Lack of pressure on purified water output| - Power light ON | Watertank hand valve closed|Turn ON the watertank hand valve| |
| | ::: | ::: | Requested pure water volume above the capacity of the water purifier|Wait the watertank is filled again\\ | | | ::: | ::: | Requested pure water volume above the capacity of the water purifier|Wait the watertank is filled again\\ | | ||
| | ::: | ::: | Lack of pressure in the pressurised watertank|Re-adjust the air-pressure of the water tank| | | ::: | ::: | Lack of pressure in the pressurised watertank|Re-adjust the air-pressure of the water tank| | ||
start.txt ยท Last modified: 2019/04/25 14:38 by thierry
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
